1·On the base of defining a side hole and an inclined hole in plastic structure, both are compared on the hand of mold design.
在对塑料制件结构中的侧孔和斜孔加以界定的基础上，从模具设计角度对两者进行了比较。
2·This paper describes the designation of a measuring instrument of the angle of the inclined hole, and develops a professional instrument which is low-cost, highly-practical and has a high precision.
文章通过斜孔角度测量仪的设计，开发了一种低成本、实用性强、精度高的专用仪器。
3·The holes of inclined multi hole wall have a strong effect on the heat transfer intensification around the hole.
多斜孔壁上的倾斜小孔抽吸气流对斜孔周围换热增强有明显的效果。
4·Drilling on inclined surfaces has such problems as the decrease of hole accuracy and damage of tools compared with the drilling on flat surfaces.
斜面上钻孔与平面上钻孔相比，由于加工初期条件差，孔的相对位置精度低，刀具更容易折损。
5·Three-dimensional numerical study is conducted to investigate the heat transfer characteristics for the inclined multi-hole film cooling with different configurations.
对三种不同结构的多斜孔气膜冷却结构进行了数值研究。
6·On the basis of energy method, the possibility of drill stem buckling in inclined straight hole is studied.
本文应用虚位移原理，在充分考虑钻柱所处的特殊环境的基础上，考察了斜直井眼中钻柱屈曲的可能性。
7·The article presents the application of technique datum hole in designing special clamps for drilling diagonal bore and finishing inclined plane, and raises calculation analysis.
论述加工斜面、斜孔零件时工艺基准孔在夹具设计时的应用，并提出了计算分析。
8·The frame node as the research object, analyzes machining problem about multi-surface inclined-hole processing, a way to express 2D view were presented;
以网架球为研究对象，分析族类零件多面斜孔的设计加工难点，提出一种平面形体的表达方法；
9·The air cylinder body inclined oil hole machining alignment system is a device for realizing the method.
气缸体斜油孔加工对准系统为实现上述方法的装置。
10·Using the method of heat-mass transfer analogy, experimental research was carried on to investigate adiabatic film effectiveness of inclined multi-hole full-coverage film cooling.
采用传热传质类比的方法，对多斜孔壁气膜冷却的绝热温比进行了实验研究。